• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Door hinge backing plate

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
Years ago we cut the rockers and made tube rockers. Realized the door posts were in bad shape, so we decided to not run doors. Quite a few of the bolts broke off in the backing plates anyway. Now we want to mount some doors and I realize we removed one of the plates while welding the posts for repair. I know I will need to cut an access hole to put a new plate in, but want to avoid removing the fender. Anyone have a way to do this? Can I cut a slit and drop the plate in, then fish it into position with a coat hanger?

Sent from my DROID RAZR using Tapatalk 2
 
Last edited:

AZ73

Bronco Guru
Joined
Mar 28, 2012
Messages
3,813
I don't think so. I just welded up the temp sensor hole in my door post, which was just above the top hinge, and there was a horizontal piece just below that so you wouldn't be able to drop it down. You might be able to push it up from a slit. I replaced the PS door post (still connected to the kick panel. I can go cut it open and see what it looks like if you give me an hour or so.
 

AZ73

Bronco Guru
Joined
Mar 28, 2012
Messages
3,813
Yup, it's in a sealed compartment, like an envelope. you can go in through the kick panel pretty easy. The door post doesn't have any panel on that side, it's just open to the kick panel, the upper one is just in front of the dash bolt nuts welded to the inside of the kick panel. However, there is a piece of metal on that side of the compartment to keep the hinge plate in place, but it looks like you can bend it out of the way, slide the new hinge plate in, and then bend it back. There isn't one on the opposite side since the door post itself keeps it from moving too much. Even if you took the fender off, you'd still have to go through that other piece to get to the hinge plate. I would definitely recommend going through the kick panel.
 

Attachments

  • rsz_img_5543.jpg
    rsz_img_5543.jpg
    179.1 KB · Views: 119
  • rsz_img_5544.jpg
    rsz_img_5544.jpg
    122.8 KB · Views: 132
Last edited:

AZ73

Bronco Guru
Joined
Mar 28, 2012
Messages
3,813
Here's what it looks like from the kick panel side.
 

Attachments

  • rsz_img_5546.jpg
    rsz_img_5546.jpg
    175.4 KB · Views: 114
  • rsz_img_5548.jpg
    rsz_img_5548.jpg
    138.4 KB · Views: 107
Top