• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Drip rail repair

DonH

Contributor
Sr. Member
Joined
Mar 8, 2013
Messages
487
Loc.
WA State 30 miles from the beach
The sealer in my 77 drip rail is hard, cracked and needs some repair. What did Ford use to fill and seal it. I am thinkng seam sealer but it will take a lot of it.
 

widowmaker77

Contributor
Sr. Member
Joined
Oct 11, 2007
Messages
564
The sealer in my 77 drip rail is hard, cracked and needs some repair. What did Ford use to fill and seal it. I am thinkng seam sealer but it will take a lot of it.
Ford used regular old seam sealer in there originally. That stuff shrinks and is the reason most all of the hardtops rust out on the inside rail. The outside drip rail runs through to the inside. So rain in the drip rail will run through and sit in the inside channel and rust the top out there. There’s a total of three pieces sandwiched together there for rust to get in. When I rebuilt my top I had to remove the side panels and replace metal under there. Once everything was welded back together, I scraped out all the leftover old seam sealer then sand blasted the drip rail channel. Sprayed two or three coats of 2k epoxy primer. I then filled the drip rail channel up all around with 3m flowable 2k seam sealer. I believe I used three or four tubes of it to do the full hardtop.
 

Torkman66

Contributor
Sr. Member
Joined
Apr 3, 2022
Messages
854
Loc.
New Braunfels, Tx
I completely restored a rusty top and filled the drip rails w2ith resin and then flexible seam sealer on top edges. Looks great.
IMG_5794.JPG

IMG_7229.jpg


IMG_7230.jpg
IMG_7248.jpg
IMG_7249.jpg
 

Attachments

  • IMG_7247.jpg
    IMG_7247.jpg
    127.4 KB · Views: 63

widowmaker77

Contributor
Sr. Member
Joined
Oct 11, 2007
Messages
564
Thanks Windowmaker. That is just about what I have found. The filler dried and cracked then rusted out. I will take your advise with the fill.
I forgot to
Mention this. That 3m 2k seam sealer takes a special gun. They aren’t cheap. I made my own out of two el cheapo caulk guns. It’s not pretty but it got the job done with no issues.
 

Attachments

  • image.jpg
    image.jpg
    379.2 KB · Views: 103
  • image.jpg
    image.jpg
    285.5 KB · Views: 66
  • image.jpg
    image.jpg
    218.2 KB · Views: 93
Top