Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.
This is where all the old posts go so they can still be used for reference and searched.
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
If you have problems registering or can't log into your account, please contact Admin.
thanks, the floor coating is one of the first things i did to the garage when i bought my house a few years ago.
No new progress on the arms. I took my daily driver 99' ram 1500 4x out for breakfast yesterday morning (with the windows down and the a/c off, weird for az in may) i heard a bad sound comming from the rear. turns out both rear axle bearings were toast and a couple wheel studs sheered off!
spent my sunday fixing the ram instead.
just did another set myself last nite...everything went ok...still sucks drilling the holes but i think its a step you need to do in case you devle. cracks in your welds...plus the bolts look kinda cool to.....i made my on own coil mount for the bottom of the spring instead of the stock two-piece....the only thing that sucks is putting the c-bushings on the axle while trying to put the cap and the arm and the bolts at the same time...lol.
I thought the same thing. However, the GIANT bolt that holds the radius arm to the frame end is not going anywhere.
I should be able to get the passenger side finished after work today so i will post a few more pics.
Thanks!
Looking good along with the welds! I don't think that they are gonna be a problem especially compard to some of the typical welds on the frames of our beloved trucks! ;D
I am putting in a high pinion full width 44 out of an f-150 though i was referring to the wedges that the caster bushing go on (see pic below). That is what i need to weld to the axle (after i set the caster to +5*). hope this makes sense?