• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

efi backfire through intake

wesleydax

Full Member
Joined
Apr 12, 2011
Messages
331
need some ideas, I just finished my 99 5.0 swap a week or so ago and it ran fine. had a few leaks so didnt drive it again till today after getting them fixed. Now it pops back through the intake after reaching cruising speed. if im accelerating its fine. i ran it up to 75 and it was smooth till i let it level out and just hold the throttle to cruise. also no issue on deceleration and no check engine light and idle is smooth. i have double checked my vacuum lines and connections. Im thinking mass air? plug wire breaking down?(there the old ones). egr has been deleted, and the only thing i dont have hooked up is the dampener on the fuel rail.
 
OP
OP
wesleydax

wesleydax

Full Member
Joined
Apr 12, 2011
Messages
331
im not ruling anything out but i dont think so. It ran great and started this all at once. no wires have been changed
 
OP
OP
wesleydax

wesleydax

Full Member
Joined
Apr 12, 2011
Messages
331
ill check them, they are a little bit of a pain to get to clip on.
 

904Bronco

Contributor
Bronco Guru
Joined
Sep 28, 2004
Messages
6,720
Loc.
San Martin, CA
If it was my track mustang I would say that it is a Lean Pop...are you sure there not any vacuum leaks you may have missed?

What type of air filter? K&N perhaps? oil might have already leaked on to the wires in the MA causing false readings.

Recheck all your connectors...
 
OP
OP
wesleydax

wesleydax

Full Member
Joined
Apr 12, 2011
Messages
331
problem solved, well not yet but i know what it is. I had the laptop hooked to it and efi guy was watching all the values while i drove down the road and talked to him on the phone. started out and it ran great went about 2 miles no issues at all, figures just my luck. told him to hold on we would turn around at the cross over and go back and i would drive it hard. well i did till the safety latch caught the hood. oh crap i hadnt closed the hood all the way. told him hang on ill close the hood and we'll do it again. slammed the hood like normal so it would latch and guess what i hear. arching fire, Gary confirmed it about the time i did. crack the hood no problem. slam it shut and its arching on passenger side. and of course it throws all values out the window and just tries to run. didn't think about coil pack clearance with a body lift. oh well that's an easy enough fix and i can sleep better knowing the solution. thanks guys for all your help
 

pcf_mark

Bronco Guru
Joined
Jun 11, 2010
Messages
3,697
I trimmed the bracket and re-welded because mine touched too! Basically I cut the mounting ears off the bottom, cut about an 1" out, welded it back together. I had the clearance for the heater nipple but it fits now. Stock no lift.

EDIS8 ROCKS.
 
Top