• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

EFI computer location pics

72_EB

Contributor
66to77
Joined
Feb 4, 2003
Messages
4,982
Working on a '77 with a stock working AM radio, so I don't want to do Lars' sweet speaker spot and bracket. Any other good spots? I might use Ryan's harness to keep it real clean too.
 

Bronco Brian

Bronco Guru
Joined
Feb 10, 2006
Messages
1,140
I have no glove box so I made a plate mounted in then used some velcro to hold Computer to it pluse I have some other electrical Stuff there too
 

COBlu77

Sr. Member
Joined
Feb 10, 2004
Messages
867
Loc.
Arvada, CO
Mine is on top of the heater directly behind the speaker hole. I used strapping to hold it in place. I'm not thrilled by the heat it must get, but so far so good. My second choice was going to be on the passenger kick panel as high up as possible. Sorry no pic is possible without taking the glove box out.
 

Broncos n' VWs

Sr. Member
Joined
Nov 6, 2005
Messages
360
Mine is on top of the heater box, directly behine the glove box. I have the Tuffy glove box and the computer stays wedged in there pretty good. It's been like that for awhile and I haven't had any issues. I have the RJM harness.
 

kntr

Bronco Guru
Joined
Oct 7, 2006
Messages
2,277
Mines mounted on the top of my inner fender. I need to move it but the bronco never sees water. Check my gallery.
 

gddyap

Bronco Guru
Joined
Mar 8, 2005
Messages
1,334
Loc.
Mtn View, CA
In the glovebox. I cut a hole in the lower left rear corner for the connector. The computer has to sit at an angle to close the door but no big deal. Used to be on top the of the heater assembly.
 

taxx

Sr. Member
Joined
Sep 18, 2004
Messages
796
Loc.
Indianapolis
No pic, but I ditched my stock drivers side vent box and put an access panel in up there. The puter is located on the drivers kick panel all the way up to the cowl on the inside of the cab. It will fit even with the vent box, I didtch the vent box cause of the VSS I used is mounted to the back of the speedo and it takes a lot of room and this way its easier to access everything.
 

TonyPDX

Contributor
Full Member
Joined
Feb 3, 2004
Messages
341
Mine hangs with the back edge just below the bottom of the dash. I run a TwEECer so I wnated the J3 port exposed for easy access.

Tony
 
Top