taxx
Sr. Member
I recently got my 73 and knew the floor pans had been replaced and the job was crappy to say the least. No big deal. I am fine with replacing the floor plans, plenty of good write ups around the web. However. The support under the drivers feet that goes up under the transmission part of the floor and down under the passengers feet has been "modified" when the floor pans were replaced in the past the guy cut them out and used sheet metal that he bent to fit, its nor right and is weak. The brace under the drivers side was replaced with angle iron and was done poorly. This has caused the drivers side to sag there and my door is missaligned. It has a larg gap int he front between it and the fender at the bottom and it smashes into the fender at the top. So its not waaaay out of wack but enough that it needs to be fixed right. He also didn't cut out the old rusted ones so they are still there from the underneath. I can manage the tear down and cutting the old crap out and cleaning it up and even replacing the floor pans, however how do I tacke the sag on the drivers side? How do I replace that support correctly and have the body re-aligned? Its not a saggy body mount they are all the same and I intend to replace them all when I do this, but I want to do this correctly before I put a cage in. I will probably tackle this in Nov - Dec but need to start planning and deciding how I go about this. i can get pics tomorrow of the "repair" that was done before if anyone needs them for it to make more sense.
Do I simply put a jack under that side until it lines back up? Do I do that before or after I cut? Obviously that will have to be replaced on both sides. Is it as siple as jacking up the body and supporting on both sides while I cut that our and weld in the new parts?
Do I simply put a jack under that side until it lines back up? Do I do that before or after I cut? Obviously that will have to be replaced on both sides. Is it as siple as jacking up the body and supporting on both sides while I cut that our and weld in the new parts?











