CA Fresh built 9" 3rd member with 4:11 gears

[Fricker08]

Hey I have a complete center section 3rd member for a 28 spline 9 inch rear end. Factory limited slip with Richmond 4:11 gears. Less than 500 miles since rebuilt by a professional. New yoke seals and bearings throughout. Not the gear ratio I thought I wanted so I'm trying to sell or trade for a good 3rd with 3:50 gears. I live in Hemet ca. Just north of temecula. Call or txt me 951-663-9264 if you have any questions

 

[joshnjulie1]

If you have a dana 30 front, I have a carrier and ring and pinion for 4.11's if you wanted to keep the rear and change out the front.

 

[Fricker08]

hey i forgot to mention.. i have a dana 44 and the 4:11s to go with this set i would be willing to sell for another $100. thank you for the offer joshnjulie

 

[ilovemaui]

Never a deal like this in my backyard.

 

[nickeboy]

Sent you a pm

 

[Fricker08]

I guess I should clear up a little. I'm not selling the Dana 44 that's just the axle I have. Just selling the matching 4:11s for a Dana 44 to the 9" center sedition. Maybe my prices are way off.. But I seen complete 9" centers with no yokes custom built for $550-600 on toms and $1200 on bronco graveyard. Not trying to get rich just replace mine with a pretty fresh 3:50 center. And I paid $100 for the Dana 44 ring n pinion. Maybe I got ripped off. Just trying to get my truck rolling again.

 

[wheelsblank27]

I got exactly what you need. I just need to confirm my new Dana 44 I'm buying has 4:11 s not 350 s. I'll find out tomorrow, also my 9" is a small bearing if that matters. Idk

 

[Fricker08]

Alright yea just let me know. And small bearing is ok. The center I have is large bearing but my housing is a 66 so it's small bearing. Either way it doesn't matter