Front Turn Signal Problem

[David63]

I recently installed a new set of front turn signals from Bronco Graveyard which only requires you to plug the turn signal electrical harness into the vehicle turn signal harness using the same connector and connect the ground wire. The turn signals work, however when I turn the park lights on, both the park light and turn signal filaments illuminate which results in no flashing front turn signal at night. Both turn signals exhibit this problem. The bulbs are correct. They original equipment I removed was working properly.

Any ideas...

 

[Steve83]

Post a link to what you bought, and photos of your installation. Do you have a stock wiring harness, or aftermarket?

 

[c0astie31]

Ok so this happened to me

The plug for the marker and the plug for the directional were mixed up
Try to swap them and see what happens?

 

[Blue71]

I had the same problem on a new set. Just clip the wires and reattach each wire to the opposite wire. It works

Blue71

 

[BigToe]

I had the same problem on a new set. Just clip the wires and reattach each wire to the opposite wire. It works

Blue71

had the same thing with a pair of used buckets, like Blue said flip flop the plug wires.

 

[Knox]

http://classicbroncos.com/forums/showthread.php?t=191789&highlight=knox

 

[David63]

Thanks for the replies. I swapped the wires and that solved the problem. I wonder why this is an ongoing problem with new signal light wiring. Oh well, glad it was a simple fix.