• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Help With Dead Bronco

buckin bronco

New Member
Joined
Jul 26, 2009
Messages
31
1969 302 Bronco.
Current history: Dead as a doornail. When I turn the key, nothing. One minute it started the next it didn't. Then it started again a few minutes later and now it's dead again and has been for a week. The battery is fully charged. The starter turns the engine when I jumped it straight from the battery over-ridding the ignition. So I figured it was the ignition switch so I ordered a new one and replaced it. That didn't take care of the problem.

Could it be the key? Or is it more likely a short somewhere from the ignition to the starter? or is it something else?

I'm completely lost and could use some trouble shooting advise.

Past History: Once before the truck died on me while I was driving. The engine just quit. I thought I just ran out of gas but as it turned out I think it was something electronic despite the fact that after I added fuel it started. I think it was just a coincidence.

Thanks,
Victor
 

Tasty Geezer

Sr. Member
Joined
Mar 11, 2008
Messages
637
look at the simple things first.
Make sure your positive cable from your solenoid to your battery has a great connection. This happened to me the other day. I would turn the key 20 times and nothong would happen, then on the 21st time it would turn over and start. The post on my battery was a little worn and the old cable couldn't tighten down on it enough. A new positive cable fixed the problem.

Sounds electrical to me, so check all your connections.
 

travis77

Full Member
Joined
Feb 9, 2009
Messages
324
Loc.
Pasadena MD
I had the same exact problem. you can read my posts to see all the great input i got. "Ignition issues" and "ignition frustration". Ended up being a bad wire on the pos side of my coil. 10 cent fix. Also check the saddle on the coil with the 2 wires going into it. Sometimes the spade connectors are loose, but you can't tell.
 
OP
OP
B

buckin bronco

New Member
Joined
Jul 26, 2009
Messages
31
I did it! I found a loose connection in the wire going to the starter. Ya hoo!
My first good luck repair! There may be hope for me yet. Thanks for the advise you guys.
 

broncomitch

Bronco Guru
Joined
Jan 17, 2008
Messages
2,384
Loc.
west jordan, utah
check the start on your starter siloind


happened to me, it wouldn't crank over but then it would tore into the wiring only to fint the little nut on that ccame loose.
 
OP
OP
B

buckin bronco

New Member
Joined
Jul 26, 2009
Messages
31
So as I'm putting everything back in it's place under the dash and in association with the ignition my hand runs across one of the wires that goes to the ignition. It was super hot. Kind of burned my hand.
That can't be good. Any idea of what is causing that?
 

broncomitch

Bronco Guru
Joined
Jan 17, 2008
Messages
2,384
Loc.
west jordan, utah
a short some place. you might have burnt your fusible link?

or the wire is to thin and is under to much load.

sorry, read all the posts and didnt know you fixed the problem. lol
 
Last edited:

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
So as I'm putting everything back in it's place under the dash and in association with the ignition my hand runs across one of the wires that goes to the ignition. It was super hot. Kind of burned my hand.
That can't be good. Any idea of what is causing that?

The ignition wire (red-green) has a wire resistor (pink) in it that gets hot. If that's the wire, it's normal.
 
OP
OP
B

buckin bronco

New Member
Joined
Jul 26, 2009
Messages
31
pink wire

I think it's pink. There is rhino over-spray on most of the wire (not my doing) and as far as i can tell i think it's pink(ish).

Thank you for your help.
Victor
 
Top