Here's an odd ball I need pulled out of a hat.

[NMWILLY]

I need 2 spring retainer plates from a stock lock out hub for my '66. It's a washer shaped plate that the tappered spring sits on. If I can't find one, can someone send me pics or even better, pics with some dimensions. I can make a couple if I have enough information. I work in a Fabrication / Machine shop.

 

[needabronco]

I just pulled my stock hubs off of my 71' they worked like a charm and look real good inside if they will work for you? PM me if you want.

 

[NMWILLY]

Thanks, I found what I needed

I'm pretty sure the '71 hubs were different than the '66 hubs. I'm doing a stock restoration on this Bronco.

I did find a N.O.S. set so I don't have to make any.

Thanks for the reply.

 

[bronconut1]

I Am Parting Out A 1966 With Those Starnge Looking Front Hubs. Bronco Only Has 23k Miles. I Am Sure There In Good Shape. Its A Dana 30 With 4.09 Gear Ratio.
Mike @ 309-256-9810.

 

[67bronco]

66 hubs

I have locking hubs out of my early 67 (many 66 parts) If you need, email directly, I'm not on this site as often.

 

[bronco60-niner]

I Am Parting Out A 1966 With Those Starnge Looking Front Hubs. Bronco Only Has 23k Miles. I Am Sure There In Good Shape. Its A Dana 30 With 4.09 Gear Ratio.
Mike @ 309-256-9810.

probably in about as good of shape as that rusted out tailgate you sold me%)