New hood, fenders, and grill. everything lines up very nice after a day of tweaks, bends, twists, and some light dolly work. Lines down hood and fenders are 5/16" on both sides and parallel. Hood arch matches fender arches. Grill mates up to fenders very nice. Rear of fenders have nice 1/4" line with doors (after much gnashing of teeth and some slight metal mod).
However, the hood is about 1/4" short. (see pics). It is about 3/16" short on the drivers side and 1/4" short on the passenger side because I used a single shim on the drivers side hinge to square up the lines with the fenders. So I know I can shim the hinges more to get the hood to match the grill tip, but how much shim is too much? I will need approximtley 1/4" shim on both sides to get the hood to match the grill. That will make a 1/4" + gap on back of hood at the windshield/cowl area. Is that OK or are there other options to consider?

However, the hood is about 1/4" short. (see pics). It is about 3/16" short on the drivers side and 1/4" short on the passenger side because I used a single shim on the drivers side hinge to square up the lines with the fenders. So I know I can shim the hinges more to get the hood to match the grill tip, but how much shim is too much? I will need approximtley 1/4" shim on both sides to get the hood to match the grill. That will make a 1/4" + gap on back of hood at the windshield/cowl area. Is that OK or are there other options to consider?




















