Ignition switch pigtail/harness

[Bitch'nBronco]

I'm going back to a stock ignition switch and don't have a pigtail anymore. Will this one work? Or does anyone know where to get one? http://www.cjponyparts.com/scott-dr...m_medium=cpc&utm_campaign=EbayCommerceNetwork

 

[Viperwolf1]

That looks like it would work.

 

[Bitch'nBronco]

Perfect thanks!

 

[DirtDonk]

If you haven't already pulled the trigger there BnB, here are some alternatives.
While it does look like the correct one, just in case you're ordering anything else through any of the Bronco vendors (or us specifically anyway) we have these: http://www.wildhorses4x4.com/product/Ignition-Switch-Socket-Pigtail
Correct one and less expensive.

You still running a stock main harness? If a Centech and going back to stock switch from their generic one, we have this too: http://www.wildhorses4x4.com/product/Centech-Stock-Ignition-Switch-Adapter which plugs right in to their harness.
You didn't say that of course, but I wanted to throw that into the mix in case your reason for not having a stock switch to begin with was due to a harness change.

Happy to throw one in the US Mail to you on Monday.
If you have to order over the weekend, I would guess a company like CJPP probably ships over the weekend(?) but if you can wait, we could ship it by Monday. If in a big hurry, it's possible that some local store even has access to them still.

thanks

Paul

 

[Bitch'nBronco]

I'll have to order that, I'd rather buy from a bronco vendor but didn't see that. I just bought the complete switch and matching door locks from your eBay store. I'll have to order that today too. Thanks

 

[DirtDonk]

Cool, thanks.

Do you still have the stock harness? Or are you going to need to re-wire that part too?

Just curious.

Paul

 

[Bitch'nBronco]

No I dont, I have an Ez wiring 21 Fuze harness. Just looked up the switch connections so I can make the new harness work. I haven't had an acc option wired in, that's the only part I need to figure out.

 

[DirtDonk]

If the EZ Wire setup has the separate ACC wire, you just need a ring-terminal on the end and it slips over the big threaded stud in the center of the ignition switch itself.

The main connector goes on first, then the ACC wire goes on the stud after that, then a nut holds both securely to the switch.

Just in case it ever crossed your mind, that center stud is most definitely NOT a ground stud! ;D
Not that you might automatically assume that, but it's been grounded many times over the years. Had to mention it.

Paul

 

[Bitch'nBronco]

Haha perfect, I appreciate the help! Can't wait to get it back out on the road, hard to believe it's almost been apart for a year.