• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Larger rear seat

Rusty1c

New Member
Joined
Jan 31, 2023
Messages
6
I have a problem with the stock rear seat in my Bronco, It's to small and I can't fit my three kids in it. I was wondering if anyone has installed a wider rear seat that can fold and tumble up against the rear of the front seats when not in use. I noticed that there is considerable room between the top of the rear tires and the top of the rear wheel tubs. The tubs are 12 inches tall and I was thinking about cutting a 6 inch tall by 5 inch wide section out of the wheel tubs to allow for a wider seat installation. Has anyone done this and if so what seat did you use?
 

Broncobowsher

Contributor
Total hack
Joined
Jun 4, 2002
Messages
37,114
Unless you have a really funky suspension (way too much lift, no travel, way small tire for the lift) you are going to run into issues with the tire going up into the wheel well when it travels.
There is the option of going FJ40 style and putting seats over the wheel wells facing each other. But anyone big will run into headroom issues pretty quick.
It's just the size of a Bronco.

And another option would be a buddy seat, center seat between the front buckets. Consider the Bronco could be had from the factory with a factory bench, same idea.

What every you do, the kids will grow fast and will outgrow the solution you come up with really quick.
 
OP
OP
R

Rusty1c

New Member
Joined
Jan 31, 2023
Messages
6
This vehicle will see very little off road use. The vehicle was lifted when we got it and I know that it has a 2" body lift and 35" tires. The distance from the top of the tire to the top of the wheel well is 12 inches. If I do the cut I will still have 7-1/2 inches of open space between the top of the tire and where I weld in a new piece. The tires are 12 inches wide and stick out beyond the rear quarter panels by about 1-1/2 inches so the tire will contact the opening in the quarter panel before it contacts the new bottom of the wheel tub.
 
Top