Hello,
I'm new to the group....so i thought i'd tap into the wealth of knowledge
out there! I have a 73 bronco that's trying to drive me crazy with a irritating
fuel pressure problem. I have a 302 that's a nice mildly built motor with
edelbrock cam, intake, carb, ceramic headers, duraspark/HEI ignition...it has
about 4K miles since the complete rebuild. Here's the problem....i noticed that it was hard to start after it had been warmed up and driven...looking
under the hood one day after starting it up and letting it run i noticed that
the fuel pressure was slowly dropping to eventually not registering on my
in line gage. Backing up a step i have the main fuel line going into a fram
cartridge style filter, from there it goes to a stock ford mechanical pump,
from the pump i have a hard line to the carburetor with a small line filter
and a nice liquid filled gage. So the first thing i did was change the big fram
filter and then the line filter....the cartridge filter showed no dirt..i had the
tanks flused during the rebuild. I then decided to check the gage...with a
new one....no diffrence. So then i thought the pump is defective...replaced it
with a new one from napa....slightly more pressure initally...but still drops to
o after running. Then i started tracing back the main fuel line...replacing anything that was rubber with new hose....same result. The engine runs very
consistently at temperature wise.....people have said vapor lock?? while i was tracing the line...it was never very close the exhaust?? I've run it without the gas caps on....same. Does anyone have any ideas for me?
This thing is killing me..........thanks in advance
I'm new to the group....so i thought i'd tap into the wealth of knowledge
out there! I have a 73 bronco that's trying to drive me crazy with a irritating
fuel pressure problem. I have a 302 that's a nice mildly built motor with
edelbrock cam, intake, carb, ceramic headers, duraspark/HEI ignition...it has
about 4K miles since the complete rebuild. Here's the problem....i noticed that it was hard to start after it had been warmed up and driven...looking
under the hood one day after starting it up and letting it run i noticed that
the fuel pressure was slowly dropping to eventually not registering on my
in line gage. Backing up a step i have the main fuel line going into a fram
cartridge style filter, from there it goes to a stock ford mechanical pump,
from the pump i have a hard line to the carburetor with a small line filter
and a nice liquid filled gage. So the first thing i did was change the big fram
filter and then the line filter....the cartridge filter showed no dirt..i had the
tanks flused during the rebuild. I then decided to check the gage...with a
new one....no diffrence. So then i thought the pump is defective...replaced it
with a new one from napa....slightly more pressure initally...but still drops to
o after running. Then i started tracing back the main fuel line...replacing anything that was rubber with new hose....same result. The engine runs very
consistently at temperature wise.....people have said vapor lock?? while i was tracing the line...it was never very close the exhaust?? I've run it without the gas caps on....same. Does anyone have any ideas for me?
This thing is killing me..........thanks in advance











