• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Lower steering shaft from BCB

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
I'm using the 4x4x2 box and the upper shaft from 74, with the rag joint removed. BCB sells three different lengths. Anyone else have a similar setup that might know what length I will need?
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,650
Are they installed yet, where you can get a basic measurement? Or are you trying to get your ducks in a row before installation?

You probably saw where he recommends the 14" one for a stock column, but it doesn't say what, if any, differences the boxes might make.
You going with double-ended splines, or a collapsible?

Paul
 
OP
OP
Chief Master Sergeant

Chief Master Sergeant

Retired U.S. Air Force
Joined
Nov 6, 2002
Messages
5,222
I'm just getting everything ready. The box is in and the column should be in today. Was planning to just use the solid lower shaft with two splines joints.
 

ET

Contributor
Bronco Guru
Joined
Jun 14, 2001
Messages
1,800
Loc.
Dallas, TX
I have BCB's lower shaft kit. It's been awhile but I really thought the shaft length Chuck gave me was 12" but it was definitely the shortest shaft they had back in 99 or 2k. This is with cut down stock straight shaft, borg ujoints, middle shaft and 75 bronco ps gearbox. Stock body lift.

edit: to add. I installed the top joint about 2 inches below the lower steering column.

Eugene
 
Top