• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

mojave heater install question

77broncoguy

Sr. Member
Joined
Nov 12, 2004
Messages
501
Loc.
Grand Rapids, MI
I just purchased a mojave heater to install. How would I want to rout the hoses so as to be able to use the heaters (factory/ and Mojave) independently or together if desired? I have no problem with the electrical side of things, my confusion comes in not knowing exactly how the heater system works completely. should I just istall the mojave between the return line on the factory setup? I would appreciate any advice you could give.
 

supermottl

Bronco Guru
Joined
Feb 18, 2002
Messages
2,360
Loc.
Indian Harbour Bch,
i'm pretty sure it's just an "out and back" loop. It shouldn't matter which way you put it in as long as it's a complete loop. I just put one in my GF's CJ. Werks OK
 

68ford

Bronco Guru
Joined
Dec 26, 2004
Messages
2,710
it might be a plumbing nightmare, but you might want to run 1 hot water line to each heater. and then use a t and run 1 return to the motor. if not you might not get much heat from the the one thats water has allready had the heat sucked out of it at the first heater. nice hot water at both heaters.
 
Top