Motor Trans question

[Zeus6872]

Good morning, I have a 69 Bronco I am working on and am getting ready to purchase the motor and transmission. My plan is to buy a new Coyote Gen 3 (M-6007-M50C) and a 10r80 from a 2019 or newer F150 4x4, which was mated to a truck 5.0. I believe the transfer case options are Dana 20 or Atlas. Just wanted to get feedback on whether this is good plan, and are there any 'gotchas'.

 

[1969]

Do you wheel the bronco or just go get ice cream?

 

[Broncobowsher]

What are your plans for a controller to run this?

 

[Zeus6872]

Do you wheel the bronco or just go get ice cream?

A very good question probably more car shows and ice cream.

 

[Zeus6872]

What are your plans for a controller to run this?

So, this site has an engine and trans controller pack https://www.fordracingbyspeedshopdirect.com/mobile/default.aspx

 

[Broncobowsher]

I would verify that the control pack is well proven to work. In stock and supported. Because there are not any good backup plans if that controller isn't good. As in the whole swap is based on that controller working.

 

[73azbronco]

Car shows and Ice cream=302/351. Unless you want to show it, then I don't think a coyote brings any additional bang for buck. research coyote builds on this site.