FL NP435, NP203, NP205, 14-bolt

[zainyD]

Ok guys/gals, here's the deal. I've been collecting parts for a while now with grand dreams of off-road domination and general awesomeness. However, I've come to the realization that I will probably end up not using these components in the long run. So, rather than them collecting dust in my garage I wanted to offer them to you all. I prefer local pick-up, but I'm willing to meet someone part-way. I'm in central Florida between Tampa and Orlando.

Edit: I just sold the NP205, but the NP203 is still available. I am willing to consider shipping the NP203 range box, input gear, or whatever other parts you might need out of it.


ORD 1" Zero-Rates with center pin bolts $30 shipped by themselves or $20 with another item

Chevy CUCV 14-bolt rear axle 4.56 gears & Detroit locker. This axle comes with all the u-bolts/spring plates and miscellaneous hardware and has 16" rims/tires mounted to it. Also included are disc brake conversion parts (NIB calipers/wheel studs/rotors/brake pads/yoke u-joint strap kit) the only thing left for you to buy are brake hoses & caliper brackets - SOLD

Ford Small Block 4spd Hydraulic clutch bellhousing (E4TA-7505-DA) 300/302/351/Cummins, includes slave cylinder bracket. I was going to use this to put a NP435 in my 94 Bronco - SOLD

Extra Slave Cylinder Bracket for above bellhousing - SOLD

NP435 4spd 4wd transmission fully rebuilt w/new synchros/gaskets/bearings includes shifter & transfer case adapter - SOLD

Ford NP203 transfer case or range box(31 spline input) - SOLD

NP205 Transfer cases (31spline inputs) - SOLD

 

[cldonley]

I need the slave cylinder bracket if you don’t mind shipping it.

 

[bronconut73]

I don't need anything Zainy but I just think its neat that you're so close.
I am in West Orange.

 

[zainyD]

cldonley, I'd be happy to ship that item. PM sent.

bronconut73, yup, we're not too far apart.

Uploaded some pictures.

 

[zainyD]

Bellhousing and slave cylinder bracket are sold.

 

[zainyD]

Just sold the NP205.

I'm willing to part out the NP203 since only the range box is needed for a doubler.

 

[jay2002]

trans

I'm in St. Cloud and interested in the trans. where are you located?

 

[zainyD]

I'm in St. Cloud and interested in the trans. where are you located?

Sir, according to MapQuest I'm about 1 hour and 15 minutes away. I'll send you a PM with the particulars, thanks.

 

[74 Bronco Billy]

Just sold the NP205.

I'm willing to part out the NP203 since only the range box is needed for a doubler.

I'm interested in the range.box. How much? I live near the Rubicon in Ca, so ground shipping a must. 95682.

Sent from my SAMSUNG-SM-G930A using Tapatalk

 

[zainyD]

Sir, I'll send you a PM and we can work out the details, thank you.

Edit: NP203 range box and all other components are still available. I can ship at the buyer's expense.

 

[zainyD]

14-bolt is sold.....

 

[zainyD]

Sold the NP435 this evening. NP203 is still available.

 

[zainyD]

NP203 sold today.