brbuilder
Full Member
- Joined
- Aug 19, 2007
- Messages
- 176
My ‘69 302 had the dipstick location on the passenger side of the oil pan plugged with a wooden dowel and covered with silicone gasket sealer. Guessing it had been leaking and it is leaking again. The dipstick tube, currently located in the front covers appears to have been removed and relocated from the oil pan location. It doesn’t fit very well, is not in great shape and does not seal to the cover very well. While upgrading to the 3g alternator I changed out the dipstick tube in the front cover and noticed that the old and new dipsticks are too long. They hit the bottom of the pan With about 1.5” sticking out of the top of the tube. Keep pushing and the dipstick bends along the bottom of the pan until the cap seats at the top. (Don’t know why I hadn’t noticed this before) Same for both the old and new dipsticks. Both dipstick tubes are the same length. I’m wondering how accurate is the oil level reading.
Would it be better to use the front cover dipstick location? Cut the dipstick so it doesn’t hit the bottom of the pan, fill with 5qts of oil and make new marks, if needed on the dipstick. (Assume filter holds 1qt)
Or buy a new press in dipstick tube for the passenger side dipstick tube location in the oil pan? Will need to replace the gasket at the dipstick tube to pan assembly.
Best way to plug/seal whichever location is not used?
Any preference/benefit to one location over the other?
Would it be better to use the front cover dipstick location? Cut the dipstick so it doesn’t hit the bottom of the pan, fill with 5qts of oil and make new marks, if needed on the dipstick. (Assume filter holds 1qt)
Or buy a new press in dipstick tube for the passenger side dipstick tube location in the oil pan? Will need to replace the gasket at the dipstick tube to pan assembly.
Best way to plug/seal whichever location is not used?
Any preference/benefit to one location over the other?











