• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Prepping small areas for paint

DC_Gearhead

Sr. Member
Joined
Dec 28, 2015
Messages
660
So I have a question for you pros out there. I’ve replaced basically all of my body panels and I’m starting to get into some areas I want to prep for paint. I want to do it right and I have a couple of questions. I want to prepare small areas at a time. I plan to get it painted in early summer.

See picture below with bare metal. What is the right way to prep this for paint? I’d like to stay away from mixing up a small batch of epoxy paint every time, but I hear using rustoleum spray packs of primer is not good. I’d love to use some metal prep and spray some rattle can, but not sure what to use. Ideas?

On bare metal do I use metal prep, then seam sealer? Or metal prep, epoxy, then seam sealer?

Ok now for prepping over epoxy primer. At my new quarters I need to use some filler. I assume I rough up the epoxy and use filler over. Is that correct? I’m using Evercoat Quantum 1. Then do I topcoat with epoxy then highbiuld? I’d love some advice.

I’ve attached a couple of pics.





Sent from my iPhone using Tapatalk
c1ed169c677d0d95c014a4bf9f55349c.jpg

4e1eafe2ce9bed5fd2fc6d8737ef544d.jpg
 

bronkenn

Contributor
Bronco Guy
Joined
Apr 27, 2017
Messages
2,717
Loc.
Southeast Ohio
I would use only epoxy primer over bare metal even if I had to mix small batches. You can go over it before the adhesion window with high build so you would just block it when you are ready for paint prep. I wouldn't mix different type supplies as it always seems to come back and bite you later. I would scuff up the old epoxy and shoot a coat over it then apply your filler over that. I know it is a few extra steps but you will be glad in the long run. I would use wax and grease remover before every step and would stay away from metal prep solvents. Ken
 
Top