I am waiting for the steel NPT fittings to arrive.
I was able to get the end cap in with a new O-ring but the retaining ring is a pain to get in. I need to get some small screw drivers and take my time. I also think I may need to use a punch to seat part of the ring as I go. I makes a very tight fit where the ring needs to fit in. I did my best to clean that area out and sand it down before I installed the cap.
I am also a bit concerned with the depth of my 1/4" NPT tapping job on the top cover. I drilled the hole with a 7/16" bit like you are supposed to but the NPT tap got to a point where it was very hard to turn it any further. I have complete threads in the hole but as you can see in my pic the fitting is roughly half way into the tick aluminum cap.
I was using a small 8MM wrench to tap the cap with a 1/4" NPT tap and some PB blast to lube it. I wonder if I should use a 12 point socket on the end of the tap and a longer 3/8" ratchet to try and get the tap deeper to widen the top taper end of the hole.
Any thoughts?
I have tapped many holes in my life but only a couple NPT tapered ones. I am afraid I will break the tap off in the hole if I push it to hard.
I was able to get the end cap in with a new O-ring but the retaining ring is a pain to get in. I need to get some small screw drivers and take my time. I also think I may need to use a punch to seat part of the ring as I go. I makes a very tight fit where the ring needs to fit in. I did my best to clean that area out and sand it down before I installed the cap.
I am also a bit concerned with the depth of my 1/4" NPT tapping job on the top cover. I drilled the hole with a 7/16" bit like you are supposed to but the NPT tap got to a point where it was very hard to turn it any further. I have complete threads in the hole but as you can see in my pic the fitting is roughly half way into the tick aluminum cap.
I was using a small 8MM wrench to tap the cap with a 1/4" NPT tap and some PB blast to lube it. I wonder if I should use a 12 point socket on the end of the tap and a longer 3/8" ratchet to try and get the tap deeper to widen the top taper end of the hole.
Any thoughts?
I have tapped many holes in my life but only a couple NPT tapered ones. I am afraid I will break the tap off in the hole if I push it to hard.











