Putting the front axle shaft back in - PIC

[brian72]

Getting ready to install the front axle shafts and I bought the parts mentioned in the F150 disk conversion article. I know where the plastic beveled bushing goes. My question is about the rubber gasket. It goes over the metal sleeve and when axle shaft is pushed in it forms a seal?

See picture - may make more sense??

thanks
brian

 

[75]

Ive done the job but for the life of me cant recall where that goes. Haynes manual has a pretty good schematic i think. someone here will know. give em a few days.

 

[77TexasBronc]

Here, Its kinda hard to see but this diagram shows it.

http://www.broncograveyard.com/dia/6/d44diaaxle.jpg

 

[Rustytruck]

Metal ring goes on inner stub axle shaft large flat surface twords the U joint, rubber seal goes on top of steel ring, thin lip edge of seal twords spindle. brass or plastic washer with large chamfer goes on inner axle chamfer twords the u-joint.