rear disc??? chuck your set up!!

[andy]

will the rotors that chuck sell in his rear disc setup clear the axel or is there machining that needs to be done? was reading a few articles and a few guys had to do some grinding on their axles???

andy

 

[j.r.nice]

If he is using Jeep front rotors like SSBC, used than the answer is probably "yes". I had "unfinished" axles as they (SSBC) called it and had to have them turned. It's no big deal. If it wasn't explained, you need to have the outer circumference of the hub turned so the rotor will fit over it.

hope this helps.

 

[Ryan]

http://www.bcbroncos.com/rdisk-masterkit+calipers.jpg
Chucks rotors go behind the axle, so you don't have to grind at all.
The Rotors are already machined to bolt on