[quote author=bronco_boy_66 link=board=5;threadid=19682;start=0#msg150944 date=1057528231]
I have worked my way to the passenger's side quarter pannel. It was pretty rough, so I torched it out. With most of it out of the way I began drilling spot welds. When I got to the back, the lip of the quarter pannel is behind another piece, but it is welded in. How do I get the rest of it out of there?
[/quote]
I did this a while back and was stumped at first. I trimmed as much of the quarter as I could along the back , just about down to flush. Then I worked my way up from the bottom drilling spot welds as I went.
When I came to where the quarterpanel was sandwiched between the other panels I spread them apart just enough with a screwdriver to see where the next spotweld was. I did this carefully so I didn't stretch or distort anything.
Once I drilled out that spot weld I again worked my way up carefully prying the panels slightly to reveal the next spotweld and drilled that out.
Once I worked my way to the top the quarter was out without any damage to the other panels.
I hope this makes sense. ???
Dave