Southbronco1
Jr. Member
- Joined
- Jan 19, 2021
- Messages
- 57
Hello friends, I’m replacing my stock leaf springs. Several of you have already been very helpful as I do this. My latest problem is with the new shackle bushings. They are Polly bushings from Tom’s. While pressing them into the new shackles I needed to use a vice and a ton of force. Is this normal? They didn’t bulge or deform, but they stopped budging with about a 1/8” to go on the one side. I’ve attached a picture. I figured this was adequate, but now trying to install the shackle (with spring attached), and it won’t go into the hanger. If the bushing was completely flush in both sides it would make it easier I think. But I’m still not sure it would go in. Is this typically a hard install? Do I need to somehow spread the hanger a bit, and if so how? I have the open face of the shackle facing toward the back of the vehicle as Tom’s insisted. This is not a lift, but rather replacing stock leafs with stock 5 pack. New shackles. Any thought greatly appreciated.











