• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

rear shackle bushings?

Kyle.malone

Bronco Guru
Joined
Mar 9, 2006
Messages
3,077
Loc.
Norman, OK
I just got in my rear shackle bushings from a Vendor. They are the poly bushings. These things are too big for the i.d of the shackle where they are suppose to go. The packing slip says they are the right ones.. I have put grease all over the shackle and the bushings, but have had no luck.. Any other ideas.
 

NicksTrix

Bronco Guru
Joined
Aug 1, 2001
Messages
6,410
sure you have the old metal sleeves that the stock bushings where sitting in are out?
how much bigger are we talking about? do you have a set of calipers to measure the parts and shackle?
 
Last edited:

WILDHORSES

Sponsor/Vendor
Bronco Guru
Joined
Nov 7, 2003
Messages
2,253
Loc.
USA
Have you removed the steel sleeve from the stock rubber bushing? If not you will need to. What Nick said.
 
OP
OP
Kyle.malone

Kyle.malone

Bronco Guru
Joined
Mar 9, 2006
Messages
3,077
Loc.
Norman, OK
I just figured that out by looking at some aftermarket shackles.. How do you remove the metal sleeve? It looks like the bushing would be a perfect fir if the metal sleeve wasn't in there. They do not want to come out with just pliers.
 

NicksTrix

Bronco Guru
Joined
Aug 1, 2001
Messages
6,410
couple ways to get them out.
you can take a hack saw apart and put the blade inside and saw away to slit it and work it out.

you can use an air chisel and drive them out

you can cut the weld on the shackle and once open it will drop out then you just reweld the shackle.*** disclaimer: don't try this at home kids if you aren't a competant welder***

what ever you decide, besure the bore is smooth of metal burrs before you puyt your new bushings in. you don't want to tear them up on any sharp edges..
 
OP
OP
Kyle.malone

Kyle.malone

Bronco Guru
Joined
Mar 9, 2006
Messages
3,077
Loc.
Norman, OK
Thanks!!!! I will give the hack saw a try... I wasn't aware that you needed to make changes on the shackle or I would have done it before I took them to get sandblasted.. Oh well. Now I know.
 

NicksTrix

Bronco Guru
Joined
Aug 1, 2001
Messages
6,410
you really don't make any changes, you just need to get all of the old bushing out. some ways can leave some slight "damage".
the old hacksaw trick works well, just take your time. you can do it.
 
OP
OP
Kyle.malone

Kyle.malone

Bronco Guru
Joined
Mar 9, 2006
Messages
3,077
Loc.
Norman, OK
I have been working on getting the old sleeve out for over an hour now. I cut the sleeve with the hacksaw and am getting no where on getting the sleeve out. Anyone have any tricks or suggestions??
 

jdcone

Sr. Member
Joined
Sep 29, 2008
Messages
565
Loc.
riverside, ca
Make another cut on the opposite side of the one you just did. It will fall out after that. It's not suppose to be easy, or we'd all be mechanics.
 
Top