• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Rear Wheel Travel Question?

va_hog

New Member
Joined
Dec 10, 2004
Messages
25
does any one know on a typicall 5.5 inch lift how much wheel drop you typically have when flexing. Measured from center of wheel at normal position to center of wheel and flexed (droped) position
 

daddyo

Full Member
Joined
Aug 9, 2003
Messages
262
Loc.
Southern California
TexasBronco said:
it will depend greatly on the type of shocks.


It shouldn't depend upon the shocks, but if the shocks are too short,
or they aren't mounted properly, then they will act as limiting straps.

Andrew
 

Big Nuf

New Member
Joined
Sep 1, 2004
Messages
21
Loc.
Tulsa, OK
I have WH rear leafs and when I ramped it to measure for shocks(with no shocks on), there was 15" difference between the compressed side and the drooped side. I don't know if that could be split evenly to say 7.5 up and 7.5 down though.
 
OP
OP
V

va_hog

New Member
Joined
Dec 10, 2004
Messages
25
ok, that helps some... so you would say 15in. total travel yes?
 

daddyo

Full Member
Joined
Aug 9, 2003
Messages
262
Loc.
Southern California
va_hog said:
ok...so i take it that no one has ever measured this before.

Sorry, I wasn't addressing your question.

I actually did measure this, for my puny 3.5" lift, when I was trying to
decide which shocks to buy. You can measure on your 5.5" lift. Jack up
one front corner and put it on a stand, then jack up the opposite rear and measure how much the other rear wheel droops.

Andrew
 
Top