• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Request for PTO information

bmc69

Contributor
Bronco Guru
Joined
Jun 11, 2004
Messages
12,015
folks seem to be sayin that the 6 & 8 cyl PTOs were different.
I have the shafts, mount, shift, U joint and PTO. Didn't want the winch as I use an ele 1.
I C the removable plate on my transfer (is it D20? my rig has a D44 up frnt). The gears need to mesh w/the D20...is it a differently geared D20 in the 8 and 6?
I thought "1 sz fits all"...

The differences between the 6 and 8 cyl kits was only in the PTO drive shaft details as far as I knew. That is illustrated pretty well in the diagram in post 16.
 

chrlsful

Bronco Guru
Joined
Oct 21, 2009
Messages
1,448
OK, thanks bmc, I didn't C any diff.
Now: just the length of 2 shaft ('self align bearing' just swivels around I think). The shifter mount might need the most attention if I have the wrong 1. I have a mishmash of both bent8 and i6 equipment here since its results of 30yr ownership.

Thanks 4 da buracuer okie! Imagine a backhoe on 1 of these...

I may make a frnt mount auger. Gotta figure how to set up a 'bumper mount' tripod yet still have a bumper & current sno plow.
The PTO would run a hydro-pump 4 it.
Didn't I C the auger on a swing arm from the bed on some of these oem ordered bronks?
Luv to develop a 'working bronk' thread/forum to challenge the great stuff seen on the 'military' one set up here.
 
Last edited:
Top