Tedster100
Chairman of the Bored
- Joined
- Aug 25, 2010
- Messages
- 1,762
Need some advice, measurements, ideas... I bought a 6 point family cage several years ago while collecting parts for my build and it's pretty much fabricated and tack welded together. My problem is that no matter how I mount the fold & tumble the rear bar is right at my head where even a little bump is going to make a lump.
My rear bar is angled in a lot and I'm finally at the point where I have to admit that the best solution seems to be to put a different hoop in the rear that is more straight up & down and not angled to the front so much.
That leaves me with the following questions:
1. What is the distance that the back of the rear hoop has to be from the inside of the tailgate to not cause problems with the new best top I will be installing? (offset distance)
2. What is the cheapest place to get a single hoop and a couple of straight pieces of 2"?
Any help would be much appreciated.
Thanks.
My rear bar is angled in a lot and I'm finally at the point where I have to admit that the best solution seems to be to put a different hoop in the rear that is more straight up & down and not angled to the front so much.
That leaves me with the following questions:
1. What is the distance that the back of the rear hoop has to be from the inside of the tailgate to not cause problems with the new best top I will be installing? (offset distance)
2. What is the cheapest place to get a single hoop and a couple of straight pieces of 2"?
Any help would be much appreciated.
Thanks.











