These maybe a lot of stupid questions but I have to ask. To give some background I am pretty much redoing most of the body (front/rear floor pans, cowl, rockers, quarters, etc) with new sheet metal. The rig is being built for a nice summer driver, mild trail capability (something like fins and things, hell's revenge (w/o hell's gate)...) which would lessen the chance for body damage. Still want to be safe as possible though.
1. if I need .5 inch clearance on each side of the bar, and my tie in member is 90 degrees to the roll cage tubing, that would mean my tie in points could translate a total on 1" vertical motion. Does the bushing completely dissipate this vertical translation? If not, I would suspect the body would start to deform at all these mounting plates.
2. What is the strength on the double plate method when using bolts? I know the bar will most likely be in compression, but if there is side forces aren't all the mounting points in double shear?
Summary, what I am looking for is the best protection I can buy without messing up the body more than the holes that are required to mount it.
thanks again for your help guys...
Josh