• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

ROuting Centech through firewall????

Warhead13

Jr. Member
Joined
Aug 8, 2005
Messages
118
Loc.
St. Augustine, Fl
Okay, I have a 1970 bronco and I pulled all the old/original/po modified wiring out. How do I route the centech harness through the firewall? It shows a hole on each side in the instructions but I only have one hole on the drivers side that isn't big enough to route that side of the harness through. I'm guessing I need to drill or cutout a hole on the passenger side to accomplish this install. Anybody know what size hole I should cut? I'm really confused and pissed at the moment and could really use some tips/information on this install.
 

stevew

Bronco Guru
Joined
Jun 21, 2001
Messages
2,123
Loc.
Elliston Montana
Spend a little more time reading the instructions . Not only do they tell you to cut a hole for the early harnesses , the size is also given .... ;)
 

JaxLax

Bronco Guru
Joined
Apr 22, 2002
Messages
3,310
Loc.
Jacksonville, FL
IIRC the earlier ones don't have the passenger side hole, so yes, you need to drill your own with a hole saw. It's in the instructions somewhere.

don't get angry. you want to wire it right or else you haven't succeeded in fixing anything.
 
OP
OP
Warhead13

Warhead13

Jr. Member
Joined
Aug 8, 2005
Messages
118
Loc.
St. Augustine, Fl
Thanks... guess I will reread the instructions again. So what should I use to cut this hole? A die grinder? Holesaw? which is better tyo use in your opinion?
I thought I had read that I needed to cut a hole when I first read through the instructions but while skimming through the instructions during my first attempt at actually installing, I didn't see it. What should I use to patch the holes from the original fuse box location?
 

stevew

Bronco Guru
Joined
Jun 21, 2001
Messages
2,123
Loc.
Elliston Montana
To block off the old fuse panel hole I just cut out a square of sheet metal & screw to the firewall & caulk it . Or if it's a resto I weld it solid .
A hole saw would be best , if you can find a metal cutting one . I use a Roto Zip with a metal bit .
 
Top