Skiddy
Bronco Guru
- Joined
- Oct 8, 2003
- Messages
- 11,587
I only give beam torque wrenches to our production floor. Their accuracy is good enough and you can easily tell when they're out of calibration. For those same reasons it is all that I own at home too.
Had a clicker go out of cal a long time ago and it cost the team I was working on a couple crank-shafts, a lot of rod bearings, and untold races before it was figured out.
After a bunch of research on the topic, torquing a fastener to achieve a particular pre-load on the fastener within a narrow tolerance window is at best a crap-shoot. Mostly for the reasons Digger listed. Better to measure the stretch and that's rarely convenient.
no doubt had the same issues with out of cal, I even changed cal frequency's, training, and training. I think I was around the time after we lost a couple rod bearings and a locked up crank they started to listen%)











