• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Securing steering box - tips?

Skiddy

Bronco Guru
Joined
Oct 8, 2003
Messages
11,587
I only give beam torque wrenches to our production floor. Their accuracy is good enough and you can easily tell when they're out of calibration. For those same reasons it is all that I own at home too.

Had a clicker go out of cal a long time ago and it cost the team I was working on a couple crank-shafts, a lot of rod bearings, and untold races before it was figured out.

After a bunch of research on the topic, torquing a fastener to achieve a particular pre-load on the fastener within a narrow tolerance window is at best a crap-shoot. Mostly for the reasons Digger listed. Better to measure the stretch and that's rarely convenient.

no doubt had the same issues with out of cal, I even changed cal frequency's, training, and training. I think I was around the time after we lost a couple rod bearings and a locked up crank they started to listen%)
 
OP
OP
TTownEP

TTownEP

Full Member
Joined
May 6, 2017
Messages
215
Thanks for all the input everyone. Got all the new hardware in and it feels like a new truck out on the road. I suspect it may have been loose when I took delivery back in September. It was a bit wander-y but I chalked it up to being old and I hadn't driven a Bronco in about 15 years.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,651
Great to hear of the improvement. When even a tiny bit of movement in something like a trackbar mount can make a noticeable difference, the movement you had in a major component like the steering box was bound to have an effect.
Nice to have it feeling more solid I bet.

Paul
 
Top