chris
No more Rock Crawler
- Joined
- Nov 27, 2002
- Messages
- 1,894
I noticed I am starting to spit out the aluminum shims on the rear axle again and I want to replace them by cutting off the stock perch and welding on new antiwrap spring perches.
I can't find a replacement perch! I can find 2" and 2.5" perches but the rear springs are 2 1/4" wide. The axle is 3" wide. I'm afraid if I use a 2.5" perch the axle will not stay straight since the U bolts will not be snug against the sides of the springs?
Anyone know where I can get these? Should not be that hard.
I can't find a replacement perch! I can find 2" and 2.5" perches but the rear springs are 2 1/4" wide. The axle is 3" wide. I'm afraid if I use a 2.5" perch the axle will not stay straight since the U bolts will not be snug against the sides of the springs?
Anyone know where I can get these? Should not be that hard.











