• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Steering linkage tips

dholder

Full Member
Joined
May 24, 2012
Messages
227
I installed WH three way adjustable tie rod/drag link set this weekend because my original long tie rod end was a little worn and had developed a shimmy at 60 mph.

The first tip is to run the nuts down all the way on all three rod ends, to make sure the threads are good. Mine, at the pitman arm end, would not go past the cotter pin hole. I had to use a die to clean it up. Of course it was the very last of the three that I installed before i found it.

The second tip concerns the rotating of the tie rod so the grease zerk is pointing up at the bumper. When you do this, at the same time, bias the twist of both outer tie rod ends toward the rear of the truck to limit how much the tie rod rotates while turning the steering wheel.
Previously, my truck would drive hands off at 80 mph and I thought it was great. After the tie rod change, it felt a little vague. During installation, I had centered the ball on all rod ends. This was allowing the tie rod to rotate up and down during steering. After I biased the two outer rod ends to limit this rotation, steering improved dramatically. It is even dramatically better than before the linkage was replaced. I also seem to get more "return to center" after a turn.
 
Top