• Just a reminder that you won't be able to start new posts or reply to existings posts in the Archive forum.

    This is where all the old posts go so they can still be used for reference and searched.
  • Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Stock Bronco Height

Nobody

Bronco Guru
Joined
Feb 15, 2005
Messages
1,215
Loc.
Stanwood
I didn't want to run the other thread off track. Can someone with a stock bronco confirm these measurements are accurate.

broncnaz said:
Try this measure from the top of the axle to the bottom of the frame the stock front measurement is about 7in the rear 6 in if you have more than that figure the differance and thats the amount of lift you have.
 

dpmerrill

Sr. Member
Joined
Dec 8, 2004
Messages
362
Loc.
Springville, UT
Those numbers sound right. Mine is stock with no body on it, and it sits at 8" in the front (The springs are brand new and I'm expecting the body to push it down about an inch).

What did yours turn out to be?
 
OP
OP
Nobody

Nobody

Bronco Guru
Joined
Feb 15, 2005
Messages
1,215
Loc.
Stanwood
dpmerrill said:
Those numbers sound right. Mine is stock with no body on it, and it sits at 8" in the front (The springs are brand new and I'm expecting the body to push it down about an inch).

What did yours turn out to be?

Mine was 9.5". I didn't realize I had that much lift. I thought I just had some stiffer springs because of the PTO.

Thanks!
 
Top