• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Stuttering motor

AZ4x4

Jr. Member
Joined
Mar 23, 2015
Messages
137
Loc.
Colorado Springs
So I just got my 302 dialed in but the timing and the valves, and I got the Motorcraft two barrel rebuilt still little bit of rust in the choke is left wide open because the Russ. Now while I'm driving down the road it drives good idols great but I feel like it's not give me everything it wants to give. Every once a while I'll have to hit the starter solenoid to get everything to work right even for the motor to start up. I'm wondering if I just need to change out the starter solenoid and I will help maybe with the electrical is what I'm thinking the problem might be? Any help with this issue would be greatly appreciated since this is about the last problem I have before I get the same to run just right. Thank you and Merry Christmas.
 

jckkys

Contributor
Bronco Guru
Joined
Mar 15, 2012
Messages
5,221
If your in Tucson now, go to Merle's, the only real parts store in town, and buy a new starter relay. I go to Pull-A-Part off Contractor's Way and look for real Motorcraft parts like starter relays in older Ford trucks. I doubt any parts store has Motorcraft parts from the '60s and '70s. I know Ford only goes back to 2005.
 

DirtDonk

Contributor
Bronco Guru
Joined
Nov 3, 2003
Messages
51,651
The ONLY way that the starter relay/solenoid should be able to effect the ignition is through the small Brown wire on the "I" post.
Disconnect it and see if anything changes. If so, then it's a good bet that you need a new relay/solenoid, which you knew already because you have to hit it to get the starter to work sometimes.

If it does not change how the engine runs, then you have two distinct problems.

One possible exception to all that is if you have "custom" wiring done by a PO that has some non-stock wires using non-stock locations.
Anything like this with yours?

Paul
 
Top