• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Third Gear knocking

moebids

Jr. Member
Joined
Mar 19, 2009
Messages
137
Loc.
Tuscaloosa
About a week ago, I noticed some shaking when I was in third gear going over about 40 mph. I have never had any shaking or anything like it before. Then I started noticing it when I was in second gear a week or so later. Now when I am in third it has started knocking when I shift in and out of the gear.

Also in the beginning, it only shook when I was pressing the gas and when I pushed the clutch and coasted, it stopped.

It is a three speed on the column. Is my transmission going out or does this sound like a clutch problem?

U Joints are not loose, I checked them when it first started.

Any ideas, or advice? Thanks in advance!
 

broncnaz

Bronco Guru
Joined
May 22, 2003
Messages
24,342
Might want to drain the tranny fluid see if there's any metal in it that will give you a idea. A few other things to consider is loose ubolts on the rear springs, bad motor mounts and or t case mounts.
 

trailpsycho

Bronco Guru
Joined
Dec 11, 2003
Messages
4,856
Make sure the output of the D20 is tight; they can loosen and make vibration and noise. Also check the yoke on the 9". The stock 3 speeds are pretty robust, but its possible yours is going. You may want to remove the inspection cover on the D20 and check it out as well. My first impression was a Ujoint or the rear CV...make sure you check those first. After that the D20 output, the 9" and then think about the tranny.

If it is the tranny, it should be easy to rebuild. However, you will can probably find someone with a pull-out for less than $100 that you can just drop in.
 
Top