NicksTrix
Bronco Guru
- Joined
- Aug 1, 2001
- Messages
- 6,410
dave, for that .120 wall i'd think about stepping up to 3/32 tungsten. you could try a .045 filler rod as well.
a gas lense and a # 6 -8 cup are the usual standard on my torch. i usually run a bit more flow, i found 15-17 is a good base for me. that works for the various angles i get into.
the inverter machines are sweet, someday i'd love to get back to a miller dynasty 300 like i used when i worked at the engine shop. the pulse feature is quite nice and you can really dial in some programs with time. until then i'm stuck with my transformer syncrowave 250 tig runner.
a gas lense and a # 6 -8 cup are the usual standard on my torch. i usually run a bit more flow, i found 15-17 is a good base for me. that works for the various angles i get into.
the inverter machines are sweet, someday i'd love to get back to a miller dynasty 300 like i used when i worked at the engine shop. the pulse feature is quite nice and you can really dial in some programs with time. until then i'm stuck with my transformer syncrowave 250 tig runner.











