• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Transfer Case knocking on floor board. Help!

cmmcd72

Jr. Member
Joined
Apr 9, 2006
Messages
50
Recently lowered my floor board and extended it all the way back to rear door jamb. Great modification. Gained about 2" of headroom even after tying seats to roll cage. Created a new tranny tunnel, lost my aux tank and moved middle body mounts back. My fabricator made the tranny tunnel to narrow so there is only about 1/2" clearance between top left part of transfer case and my drivers floor board. Fixing that part of the tunnel today. The problem is that I hear a major knocking sound on the floor board when I hit minor bumps, especially when I start off. I assume it's my transfer case. Is it normal to get that much movement in the transfer case or do I have loose mounts or something? Thanks for helping.
 

t.lay

Bronco Guru
Joined
Mar 17, 2005
Messages
1,261
Loc.
Grayslake, IL
your t-case shouldn't be moving around much. Take a look at your mounts - maybe time for some new poly mounts. Also take a look at your body mounts. You can get a bit of movement going on with wore out old rubber mounts.
 

bludorbronc

Sr. Member
Joined
Apr 19, 2006
Messages
653
check engine mounts also engine could be rocking might need super extreme poly motor mounts. if poly engine and transfer case mounts are used nothing is going to move. maybe just a couple extra washers on body mounts for more clearance.
 
OP
OP
C

cmmcd72

Jr. Member
Joined
Apr 9, 2006
Messages
50
I'll change out mounts before cutting up tranny tunnel.

Thanks for the replies. Ordered new poly mounts and hardware. I have a newer 2" body lift already. Now the two questions are; how easy is it to replace transfer case mounts? Will I eventually need more than 1/2" of clearance between floor board?
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
Should be pretty easy to replace the tcase mounts if you can raise the tcase 1/4-1/2".
 
Top