86Horn_EB_77
Jr. Member
Found a deal on some Trick Flow High port heads - they have two sets of header bolts per exhaust port. Good deal but worried that these are only good for go-fast Mustang Boys.
Planning to use these on a 331 stroker with BC Broncos headers.
Worried that none of the Bronco vendor headers are designed for "high port" small block heads.
Running an auto so don't need to clear a clutch linkage. (AOD first, then 4R70W). EFI with Edelbrock RPM II or ported GT40 upper/lower
2.05 intakes/60cc chambers - planning to use with a -4cc piston
So - will any Bronco headers fit?
Any other glaring reason not to use these heads?
Will be mostly a street bronco but I'd still like it to have decent torque. Haven't picked the cam yet. This engine might see a blower some day so don't want to go too high on the CR. Not a daily driver so don't mind running 93 Octane in it.
Thoughts people?
Planning to use these on a 331 stroker with BC Broncos headers.
Worried that none of the Bronco vendor headers are designed for "high port" small block heads.
Running an auto so don't need to clear a clutch linkage. (AOD first, then 4R70W). EFI with Edelbrock RPM II or ported GT40 upper/lower
2.05 intakes/60cc chambers - planning to use with a -4cc piston
So - will any Bronco headers fit?
Any other glaring reason not to use these heads?
Will be mostly a street bronco but I'd still like it to have decent torque. Haven't picked the cam yet. This engine might see a blower some day so don't want to go too high on the CR. Not a daily driver so don't mind running 93 Octane in it.
Thoughts people?











