Type/ location of trans cooler

[toddz69]

ToddZ- thanks for the link. Do you by chance have the dimensions for this (length and height)? I looked at JBGs site but no dimensions listed. Same for Summit- no dimensions listed.

I am limited to about 13" wide by 4" high if I mount on the bottom of the core support. If I mount vertically to the L of the hood latch, I am limited to about 10" high by 6" wide. Deoth for either mounting location can be up to 3 inches.

I would prefer to not have to mount between bumper and crossmember because that will require some fab of a protective mount since I wheel it pretty hard.

This one would be far too large for your available space. It's about 22-23" wide and about 6" tall. Amazingly, I wasn't able to find the specs on it in my google searching either although I have many times in the past.

Todd Z.

 

[mgb0302]

ToddZ. Thanks! Frustrating when the inter web lets you down!!! I'll keep searching for dimensions.

NVRSTK- I'll take you on the offer for some pics. If you can't post here, I'll send my email to your PM. Thanks

 

[nvrstuk]

I'll post up. The SD cooler isn't mounted but I'll walk out and get a pic of it so you can see how it is laid out

 

[nvrstuk]

Here are 3 different SD coolers.

These in frt of the radiator with a separate stacked plate fan driven cooler...

 

[nvrstuk]

Here is the mounting of my fan driven Derale under my radiator between the frt crossmember and bumper. It is 100% covered with a 3/16" plate so I don't ha e to worry about crashing down on rock with it..
...prevention is worth a lot.