I replaced the IVR regulator hoping that the Oil and temp gauge would start working and they did not. Replaced the oil sending unit and still no go. The gas gauge works sometimes and sometimes not, what else can be my issue here?
Community
Message Forum
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Photo Gallery
Event Calendar
Book Reviews
Bronco Wallpaper
Bronco FAQ
Link Back to CB!
Buy / Sell
Bronco Tech
3 Arm Wiper Setup
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
Fix Motor Mount
Roll Cage Braces
Throttle Body 65mm
Wheel Alignment
Heat Riser Replacement
Vent Window Repair
Center Console Mount
Straighten Bumper
Ford 6R80 6 spd
More Tech...
-
Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!If you have problems registering or can't log into your account, please contact Admin.
Voltage regulator and gauge question
- Thread starter Brittain
- Start date
Justafordguy
Bronco Guru
- Joined
- Sep 26, 2009
- Messages
- 6,253
Could be a bad ground, bad guages, bad wire to the sending units, or no power to the IVR.
How? Where are all my grounds at i can check?
I went through hell with my gauges when I did my harness. They would go crazy. I ran grounds and everything I could think of. It ended up being the new regulator. I put the old 40 year old one back in and has been working fine.
Similar threads
