zf guys a lil help please

[pullnpray]

Finally got everything minus an adapter kit to put my 351 zf in, im selling my original 289 3 speed to a guy who needs as much as possible of the drive train, so my question is i pulled the transfercase off at the rear of the intermediate housing all i need is the gear infront of the snap ring on the spud shaft right?

 

[Hozr]

Not sure if it helps, I can't remember right now.

http://www.advanceadapters.com/downloads/50-4303.pdf

The directions suck, this is all you get with it.

 

[Deano]

as long as the 13 needle barrings are in there and you get the gears that are held in by the C clip you should have everything

 

[pullnpray]

Haha good old needle bearings, gotta love them i ordered a rebuild kit so im hoping it comes with new either way i got lucky and they stayed in thanks for the info guys

 

[707Bronk]

I did not get the dana 20 input gear or c-clip with the AA kit, I only recieved the spud shaft, bearing and bearing retainer/housing.

 

[Deano]

You have to reuse your gears and C clip by transferring them to the new spud shaft