- Joined
- Jan 13, 2015
- Messages
- 105
Wanted a sturdy winch bumper for a 1971 project and had an old PTO bumper from a '66 U13.
Removed the old '66 PTO winch and added steel where the old winch was and made a plate so the top of bumper is flat.
Got a warn 10-s with synthetic rope.
Problem is the upper horizontal roller is in the way of the new winch line.
No bolts or snap rings visible. Is there a way to remove it without cutting it off?
The vertical and lower horizontal rollers are well out of the way.
Any ideas are appreciated.
Removed the old '66 PTO winch and added steel where the old winch was and made a plate so the top of bumper is flat.
Got a warn 10-s with synthetic rope.
Problem is the upper horizontal roller is in the way of the new winch line.
No bolts or snap rings visible. Is there a way to remove it without cutting it off?
The vertical and lower horizontal rollers are well out of the way.
Any ideas are appreciated.
