• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

Transfer Case vent options

trailpsycho

Bronco Guru
Joined
Dec 11, 2003
Messages
4,856
Do the output shafts spin? What can happen is that they are misalligned (currently). Rotate them relative to each other and then try to shift. Its also common when you are in forward or reverse and go to shift the TC, sometimes things are just a little off and it wont shift, bump it a little and everything realigns and all is good. Dont fret.
 

zerostar2410

Sr. Member
Joined
May 19, 2009
Messages
612
Do the output shafts spin? What can happen is that they are misalligned (currently). Rotate them relative to each other and then try to shift. Its also common when you are in forward or reverse and go to shift the TC, sometimes things are just a little off and it wont shift, bump it a little and everything realigns and all is good. Dont fret.

Thats what used to happen. Gears were misaligned and i would spin the output shafts and pull on the shift rails and it would shift. Now i try to do the same exact thing and get nothing. T-case wont shift.
 

Buldozer

Bronco Virtuoso
Joined
Oct 17, 2007
Messages
3,066
Loc.
God's Country
I had the exact same problem with my case after I rebuilt it and it turned out it was nothing other than the lube I used had stuck the detent balls in place so well they would not turn loose. I had to remove the springs and remove the balls and it shifted fine without the balls and springs then I put them back and it has been fine ever since.
 
Top