WyleCoyote
Bronco Guru
- Joined
- May 2, 2002
- Messages
- 1,739
So a while back I purchased Tom's Bronco Part Rocker guard/nerf steps. Great product, really beefy, nicely built, the welds are great, overall I'm really happy with them....but....I didn't like the idea of just screwing them to the sheetmetal of the rocker, and they say to not use them as a step in the instructions....so I modified the installation a bit, and now they aren't going anywhere.
What I did:
1. Get a piece of 1/4" plate steel 5" wide cut to fit in the inside of the rocker panel.
2. Mark and drill the top bolts all the way through the rocker and 1/4" plate.
3. Mark, drill and tap the bottom bolts into the 1/4" plate.
4. Weld the 1/4" plate to the inside of the rocker, through bolt the top bolts with nylok nuts, install the bottom bolts with lock washers.
Now, the all the bolts are pulling against a 36" x 5" piece of 1/4" steel that is welded to the body, don't think it is going anywhere! If I notice any flex in it I will build a frame tie to the 1/4" plate.
What I did:
1. Get a piece of 1/4" plate steel 5" wide cut to fit in the inside of the rocker panel.
2. Mark and drill the top bolts all the way through the rocker and 1/4" plate.
3. Mark, drill and tap the bottom bolts into the 1/4" plate.
4. Weld the 1/4" plate to the inside of the rocker, through bolt the top bolts with nylok nuts, install the bottom bolts with lock washers.
Now, the all the bolts are pulling against a 36" x 5" piece of 1/4" steel that is welded to the body, don't think it is going anywhere! If I notice any flex in it I will build a frame tie to the 1/4" plate.











