• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

EEC-IV code reader...

Crewwzin

Bronco Guru
Joined
Mar 9, 2008
Messages
1,087
Loc.
Freeport, Fl
Last night roughly around 11:00pm I finally got around to trying to fire my truck up. I pre-emptively bought a code reader because I dont count too good and my attention span just doesnt allow to sit and watch blinky lights. So I plug it up like Ryan says to do on the interwebs and press test with the key in the on position. Annnndddd, nothing. For some reason, it wasnt going into test mode. Any particular reason affiliated with the truck that could cause this?
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
ECU type may not match the TRANS selection plug.

What are you pressing? Did you ground the self test terminal?
 
OP
OP
Crewwzin

Crewwzin

Bronco Guru
Joined
Mar 9, 2008
Messages
1,087
Loc.
Freeport, Fl
First, I turned it on, then I pressed "test".

The self test plug just plugs into the code reader. It didnt say anything about grounding it as well.
 
OP
OP
Crewwzin

Crewwzin

Bronco Guru
Joined
Mar 9, 2008
Messages
1,087
Loc.
Freeport, Fl
Did you connect both plugs to the reader?

Yup...did all that. I was just reading through the manual and it says to run the engine up to operating temp before running the self-test. I did not do this. Could this be the issue?
 

Steve83

Bronco Guru
Joined
Jul 16, 2003
Messages
9,360
Loc.
Memphis, TN, USA, Earth, Milky Way
That will only cause a few spurious (operator-error) codes; it won't prevent the EEC from delivering codes. Read that caption & try it with the paperclip just to see if you can get blink codes. If it begins blinking, DON'T remove the jumper wire until it stops - if you do, you'll erase all the codes. Either let it finish, or turn the key off before pulling the jumper.

BTW
Whether you use a scanner or not, a jumper is a quick, easy, cheap failsafe to have in the truck, and scratching the terminal names into the DLC makes it easy to use:

 
Last edited:
Top