PocketKings
New Member
So, I joined the Bronco owner's club a few weeks ago. Love it, love working on it, etc. It's a '73 and a beauty.
There's just one thing.
It's been having electrical 'issues' that have me stumped. I got it and it ran fine, then suddenly wouldn't start. I alternated between having power to other places and not (lights, radio, etc.). I checked the likely culprits - fuses (replaced), battery, battery cables (replaced), starter solenoid (replaced).
One day, it started and ran OK for 2 weeks. I believed the issue was the neutral safety switch and some blown fuses, because the combination of messing with both got it running. However, gauges were acting funny/sporadic, turn signal would work occasionally, etc. I figured I'd have time to check it all out when I got back from vacation to look for another culprit.
Came back from vacation after we'd had a ton of rain and had no power. I charged the battery and got it going fine again. Next day, nothing. No power at all. Charged battery full and still no power. Checked battery for dropped cell and it's fine and fully charged (I was hoping).
So I'm back to the diagnosis phase. I stripped off all of the electrical tape on the main wiring harness to check wiring. Fusible links look good, but while checking I found a burned up wire that I can't seem to identify off of the available diagrams.
Off my alternator are three wires - Black/Yellow, Orange, and Black/Red. The Black/Red is fried in multiple places from the pigtail connector to where it connects to the bolt that holds the voltage regulator in place. So, this leaves me to think it's a ground? It needs replacing, regardless. Black/Yellow and Orange go through firewall to parts unknown.
Here's the crazy part. I disconnect the pigtail in preparation to replace the Black/Red wire and now it starts like a charm. I have full power to everything I've checked, but don't want to run it too long with the pigtail undone.
I'm obviously going to replace that wire, as it's the only one that's bad (and it's very bad). I am curious why the truck starts now and what, exactly, that wire is. Most importantly - could this be the cause to some/all of my issues?
There's just one thing.
It's been having electrical 'issues' that have me stumped. I got it and it ran fine, then suddenly wouldn't start. I alternated between having power to other places and not (lights, radio, etc.). I checked the likely culprits - fuses (replaced), battery, battery cables (replaced), starter solenoid (replaced).
One day, it started and ran OK for 2 weeks. I believed the issue was the neutral safety switch and some blown fuses, because the combination of messing with both got it running. However, gauges were acting funny/sporadic, turn signal would work occasionally, etc. I figured I'd have time to check it all out when I got back from vacation to look for another culprit.
Came back from vacation after we'd had a ton of rain and had no power. I charged the battery and got it going fine again. Next day, nothing. No power at all. Charged battery full and still no power. Checked battery for dropped cell and it's fine and fully charged (I was hoping).
So I'm back to the diagnosis phase. I stripped off all of the electrical tape on the main wiring harness to check wiring. Fusible links look good, but while checking I found a burned up wire that I can't seem to identify off of the available diagrams.
Off my alternator are three wires - Black/Yellow, Orange, and Black/Red. The Black/Red is fried in multiple places from the pigtail connector to where it connects to the bolt that holds the voltage regulator in place. So, this leaves me to think it's a ground? It needs replacing, regardless. Black/Yellow and Orange go through firewall to parts unknown.
Here's the crazy part. I disconnect the pigtail in preparation to replace the Black/Red wire and now it starts like a charm. I have full power to everything I've checked, but don't want to run it too long with the pigtail undone.
I'm obviously going to replace that wire, as it's the only one that's bad (and it's very bad). I am curious why the truck starts now and what, exactly, that wire is. Most importantly - could this be the cause to some/all of my issues?











