• Welcome to ClassicBroncos! - You are currently viewing the forums as a GUEST. To take advantage of all the site features, please take a moment to register. It's fast, simple and absolutely free. So please join our community today!
    If you have problems registering or can't log into your account, please contact Admin.

1974 auto Steering column rebuild

bgood96861

Jr. Member
Joined
Jul 11, 2010
Messages
71
Loc.
Aurora, Colorado
Hey guys,


Any tricks to getting the lower bearing onto the steering shaft. They are identical diameters but I can not get the bearing to slide onto the shaft. any ideas would be great!

Thanks!
Brian Good
 

Viperwolf1

Contributor
electron whisperer
Joined
Aug 23, 2007
Messages
24,451
Have you measured the ID of both bearings and the OD of the shaft? It might be a press fit if the bearing's ID is only a couple thousands smaller than the OD of the shaft. I've gotten by without a press by using hot and cold to install bearings.
 

bronconut73

Bronco Guru
Joined
Aug 7, 2012
Messages
9,919
Hey guys,


Any tricks to getting the lower bearing onto the steering shaft. They are identical diameters but I can not get the bearing to slide onto the shaft. any ideas would be great!

Thanks!
Brian Good

Just did this on mine recently. I used a little emory cloth on the shaft then put a little oil on the shaft. My lower bearing slid right on with a nice snug fit. No hammer needed.
 
Last edited:
Top